how to draw skeleton hands on your hands

In this article, I will explicate the skeleton and proportions as an intermediate step in how to depict hands.

Allow's take a await at the skeleton and proportions of the hand.

The skeleton of the paw

First, allow's look at the skeleton of the mitt.

As shown in the figure, the mitt is divided into three parts: the wrist (carpal bones), the palm (metacarpals), and the fingers (phalanges).

In addition, the carpal basic are divided into smaller bony masses, but we will not explain and illustrate them in particular here.

The joint that connects the metacarpals to the phalanges is besides called the metacarpophalangeal joint.

In this commodity, the metacarpophalangeal joint is the key point.

Characteristically, the bones of the palm part of the hand are separated 1 by one, and each of them is connected to a finger bone.

Ratios of the mitt

Now let's look at the general proportions of each office of the manus.

The length from the wrist to the metacarpal bone is the same as the length from the metacarpal bone to the tip of the centre finger.

Also, the length from the metacarpophalangeal articulation to the 2d joint of the heart finger and the length from the second joint of the middle finger to the fingertip are the same length.

Notice that the starting point of the ratio is the metacarpophalangeal joint.

Notation that the starting point of the ratio is non where the fingers are separated.

Note where the fingers part!

When drawing easily, it is easy to get confused almost where the fingers divide.

The position where the fingers start is different if you lot are looking at it from the back of the hand or from the palm of the mitt.

The reason for this is that there is a thin layer of peel between the fingers.

When viewed from the dorsal side of the hand, the signal where the fingers separate almost coincides with the position of the metacarpophalangeal joint.

In contrast, when viewed from the palm side, the fingers are divided above the metacarpophalangeal joint.

This is why fingers wait longer when viewed from the back of the hand and shorter when viewed from the palm of the hand.

How to describe a hand

With the above points in mind, let's summarize a elementary way to draw a hand.

How to draw the back of the hand

Depict a foursquare as a bite for the back of the manus (carpal bone and metacarpal expanse).

The metacarpophalangeal articulation can be fabricated to wait more like a mitt past lightly arching the ring and pinky finger parts.

Draw a line the same length every bit the length from the carpal bone to the metacarpophalangeal joint to get the seize with teeth of the center finger.